Poly-3-hexylthiophene (P3HT) nanofibers are semiconducting high-aspect ratio nanostructures with anisotropic absorption and birefringence properties found at different regions of the optical spectrum. In addition, P3HT nanofibers possess an ability to be aligned by an external electric field, while being dispersed in a liquid. In this manuscript we show that such collective ordering of nanofibers, similar to liquid crystal material, significantly changes the properties of transmitted light. With a specially fabricated opto-fluidic component, we monitored the phase and transmission modulation of light propagating through the solution of P3HT nanofibers, being placed in the electric field with strength up to 0.1 V/μm. This report describes a technique for light modulation, which can be implemented in optical fiber-based devices or on-chip integrated components.

This Letter reports the electro-optical (EO) effect of Poly(3-hexylthiophene-2,5-diyl) (P3HT) nanofibers colloid in a polymer micro-fluidic EO cell. P3HT nanofibers are high aspect ratio semiconducting nanostructures, and can be collectively aligned by an external alternating electric field. Optical transmission modulated by the electric field is a manifestation of the electro-optical effect due to high inner crystallinity of P3HT nanofibers. According to our results, the degree of alignment reaches a maximum at 0.6 V/μm of electric field strength, implying a big polarizability value due to geometry and electrical properties of P3HT nanofibers. We believe that one-dimensional crystalline organic nanostructures have a large potential in EO devices due to their significant anisotropy, wide variety of properties, low actuation voltages, and opportunity to be tailored via adjustment of the fabrication process.

Poly-3-hexylthiophene (P3HT) nanofibers are 1D crystalline semiconducting nanostructures, which are known for their application in photovoltaics. Due to the internal arrangement, P3HT nanofibers possess optical anisotropy, which can be enhanced on a macroscale if nanofibers are aligned. Alternating electric field, applied to a solution with dispersed nanofibers, causes their alignment and serves as a method to produce solid layers with ordered nanofibers. The transmission ellipsometry measurements demonstrate the dichroic absorption and birefringence of ordered nanofibers in a wide spectral range of 400–1700 nm. Moreover, the length of nanofibers has a crucial impact on their degree of alignment. Using electric birefringence technique, it is shown that external electric field applied to the solution with P3HT nanofibers can cause direct birefringence modulation. Dynamic alignment of dispersed nanofibers changes the refractive index of the solution and, therefore, the polarization of transmitted light. A reversible reorientation of nanofibers is organized by using a quadrupole configuration of poling electrodes. With further development, the described method can be used in the area of active optical fiber components, lab-on-chip or sensors. It also reveals the potential of 1D conducting polymeric structures as objects whose highly anisotropic properties can be implemented in electro-optical applications.​

Poly-3-hexylthiophene (P3HT) nanofibers are 1D crystalline structures with semiconductor properties. When P3HT nanofi bers are dispersed in nonconducting solvent, they react to external alternate electric field by aligning along the field lines. This can be used to create layers of ordered nanofi bers and is referred to as alternating current poling method. P3HT nanofi bers with three different size distributions are fabricated, using self-assembly mechanism in marginal solvents, and used for the alignment studies. Anisotropic absorption of oriented 2 mu m long nanofi bers exponentially increases with the magnitude of applied field to a certain asymptotic limit at 0.8 V mu m(-1), while 100-500 nm long nanofi bers respond to electric field negligibly. Effective optical birefringence of oriented 2 mu m long nanofi bers is calculated, based on the phase shift at 633 nm and the average layer thickness, to be 0.41. These results combined with further studies on real-time control over orientation of P3HT nanofi bers in liquid solution or host system are promising in terms of exploiting them in electroabsorptive and electrorefractive applications.

In this work, the development of a point-of-care (PoC) system to capture aerosol from litres of air directly onto a microfluidic lab-on-chip for subsequent analysis is addressed. The system involves an electrostatic precipitator that uses corona charging and electrophoretic transport to capture aerosol droplets onto a microfluidic air-to-liquid interface for downstream analysis. A theoretical study of the governing geometric and operational parameters for optimal electrostatic precipitation is presented. The fabrication of an electrostatic precipitator prototype and its experimental validation using a laboratory-generated aerosolized dye is described. Collection efficiencies were comparable to those of a state-of-the-art Biosampler impinger, with the significant advantage of providing samples that are at least 10 times more concentrated. Finally, we discuss the potential of such a system for breath-based diagnostics.

The nanofiber morphology of regioregular Poly-3- hexylthiophene (P3HT) is a 1D crystalline structure organized by π - π stacking of the backbone chains. In this study, we report the impact of electric field on the orientation and optical properties of P3HT nanofibers dispersed in liquid solution. We demonstrate that alternating electric field aligns nanofibers, whereas static electric field forces them to migrate towards the cathode. The alignment of nanofibers introduces anisotropic optical properties, which can be dynamically manipulated until the solvent has evaporated. Time resolved spectroscopic measurements revealed that the electro-optical response time decreases significantly with the magnitude of applied electric field. Thus, for electric field 1.3 V ·μm-1 the response time was measured as low as 20 ms, while for 0.65 V ·μm-1 it was 110-150 ms. Observed phenomenon is the first mention of P3HT supramolecules associated with electrooptical effect. Proposed method provides real time control over the orientation of nanofibers, which is a starting point for a novel practical implementation. With further development P3HT nanofibers can be used individually as an anisotropic solution or as an active component in a guest-host system.

AC electric poling introduces in P3HT nanofibers anisotropic electro-optical response and birefringence. Along with birefringence, such material exhibits strong amplitude modulation which makes it more efficient alternative to liquid crystals.

AC poling allowing to control the orientation of P3HT nanofibers, result in strong optical birefringence with promising implementation in a novel type of optical modulator, without necessary embedding into any hosting matrix, e.g. liquid crystal.