Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Combined effect of physical properties and convective heat transfer coefficient of nanofluids on their cooling efficiency
KTH, Skolan för industriell teknik och management (ITM), Energiteknik, Tillämpad termodynamik och kylteknik.
KTH, Skolan för industriell teknik och management (ITM), Energiteknik, Tillämpad termodynamik och kylteknik.
Vise andre og tillknytning
2015 (engelsk)Inngår i: International Communications in Heat and Mass Transfer, ISSN 0735-1933, E-ISSN 1879-0178, Vol. 68, s. 32-42Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

The advantages of using Al2O3, TiO2, SiO2 and CeO2 nanofluids as coolants have been investigated by analysing the combined effect of nanoparticles on thermophysical properties and heat transfer coefficient. The thermal conductivity and viscosity of these nanofluids were measured at two leading European universities to ensure the accuracy of the results. The thermal conductivity of nanofluids agreed with the prediction of the Maxwell model within +/- 10% even at elevated temperature of 50 oC indicating that the Brownian motion of nanoparticles does not affect thermal conductivity of nanofluids. The viscosity of nanofluids is well correlated by modified Krieger-Dougherty model providing that the effect of nanoparticles aggregation is taken into account. It was found that at the same Reynolds number the advantage of using a nanofluid increases with increasing nanofluid viscosity which is counterintuitive. At the same pumping power nanofluids do not offer any advantage in terms of cooling efficiency over base fluids since the increase in viscosity outweighs the enhancement of thermal conductivity.

sted, utgiver, år, opplag, sider
2015. Vol. 68, s. 32-42
HSV kategori
Identifikatorer
URN: urn:nbn:se:kth:diva-159213DOI: 10.1016/j.icheatmasstransfer.2015.08.011ISI: 000365057200006Scopus ID: 2-s2.0-84941108099OAI: oai:DiVA.org:kth-159213DiVA, id: diva2:783320
Merknad

Updated from "Manuscript" to "Article". QC 20150907

Tilgjengelig fra: 2015-01-26 Laget: 2015-01-26 Sist oppdatert: 2017-12-05bibliografisk kontrollert
Inngår i avhandling
1. Single Phase Convective Heat Transfer with Nanofluids: An Experimental Approach
Åpne denne publikasjonen i ny fane eller vindu >>Single Phase Convective Heat Transfer with Nanofluids: An Experimental Approach
2015 (engelsk)Doktoravhandling, med artikler (Annet vitenskapelig)
Abstract [en]

Nanofluids (NFs) are engineered colloids of nanoparticles (NPs) dispersed homogenously within base fluids (BFs). Due to the presence of NPs, the thermophysical and transport properties of BFs are subject to change. Existing technologies for cooling electronics seem to be insufficient and NFs, as reported in several studies, might offer a better alternative to liquid cooling. The main purpose of this study, by choosing a critical approach to existing knowledge in the literature, is to investigate experimentally the potential for replacing BFs with NFs in single–phase flow. Several NFs (mainly water based metal oxide NFs) were synthesised, and different experiments (including thermal conductivity, viscosity, heat transfer coefficient, and shelf stability) were performed.

The thermal conductivity and the viscosity of several NFs were measured at both near room and elevated temperatures; the results are reported and compared with some correlations. It is shown that the Maxwell model for thermal conductivity and the modified Krieger–Dougherty model for viscosity can be used to predict these properties of NFs within ±10% error, even at elevated temperatures.

A screening setup, including a test section with d = 0.5 mm and L = 30 cm, was designed for measuring the heat transfer performance of NFs in laminar flow. In addition a closed–loop setup with a 3.7 mm inner diameter and 1.5 m length test section was also designed to measure the heat transfer coefficients in both laminar and turbulent flow with higher accuracy. Based on the results, classical correlations for predicting Nusselt number and friction factor in a straight tube are still valid for NFs within ± (10 – 20)% error provided that the correct thermophysical properties are used for NFs.

Different methods of comparing cooling performance of NFs to BFs are then investigated. Comparison at equal Reynolds number, the most popular method in the literature, is demonstrated both experimentally and analytically to be misleading. However, if the most correct criterion (at equal pumping power) is chosen, a small advantage for some NFs over their BFs should be expected only under laminar flow. The investigation concludes with the proposition of a unique method and apparatus to estimate the shelf stability of NFs.

Abstract [sv]

Nanofluider (NF) kallas suspensioner av nanopartiklar (NP) i en vätska (base fluid, BF). Tillsatsen av nanopartiklar leder till förändring av vätskans termodynamiska- och transport-egenskaper vilket eventuellt kan utnyttjas för att anpassa egenskaperna efter speciella behov.

Befintliga teknologier för kylning av elektronik tenderar att vara otillräckliga och nanofluider kan, som föreslagits i olika studier, ge en möjlighet att åstadkomma effektivare vätskekylning än dagens kylmedier. Huvudsyftet med denna studie har varit att kritiskt granska tidigare publicerad information om nanofluider samt att genom nya tester av många olika nanofluider undersöka potentialen för att ersätta vanligt förekommande kylvätskor med nanofluider i tillämpningar utan fasändring. Ett stort antal nanofluider, huvudsakligen vattenbaserade metall-oxid nanofluider, karakteriserades genom bestämning av värmeledningstal, viskositet, värmeövergångstal vid rörströmning och möjlig lagringstid. De experimentella resultaten analyseras i detalj och jämförs med korrelationer från litteraturen.

sted, utgiver, år, opplag, sider
Stockholm: KTH Royal Institute of Technology, 2015. s. x, 116
Serie
TRITA-REFR, ISSN 1102-0245 ; 15:01
Emneord
nanofluid, convective heat transfer, thermal conductivity, viscosity, heat transfer coefficient, performance, pumping power, Reynolds number, shelf stability
HSV kategori
Identifikatorer
urn:nbn:se:kth:diva-159199 (URN)987-91-7595-414-1 (ISBN)
Disputas
2015-02-05, Sal F3, Lindstedtsvägen 26, KTH, Stockholm, 10:00 (engelsk)
Opponent
Veileder
Merknad

QC 20150126

Tilgjengelig fra: 2015-01-26 Laget: 2015-01-23 Sist oppdatert: 2015-01-27bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekstScopus

Personposter BETA

Palm, Björn E.

Søk i DiVA

Av forfatter/redaktør
Bitaraf Haghighi, EhsanGhanbarpour, MortezaKhodabandeh, RahmatollahPalm, Björn E.
Av organisasjonen
I samme tidsskrift
International Communications in Heat and Mass Transfer

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 746 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf