Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Control of HCCI During Engine Transients by aid of Variable Valve Timings Through the use of Model Based Non-Linear Compensation
KTH, Skolan för industriell teknik och management (ITM), Maskinkonstruktion (Inst.), Maskinkonstruktion (Avd.).
KTH, Skolan för industriell teknik och management (ITM), Maskinkonstruktion (Inst.), Maskinkonstruktion (Avd.).
KTH, Skolan för industriell teknik och management (ITM), Maskinkonstruktion (Inst.), Maskinkonstruktion (Avd.).ORCID-id: 0000-0002-7550-3134
Visa övriga samt affilieringar
2005 (Engelska)Ingår i: SAE transactions, ISSN 0096-736X, Vol. 114, nr 3, s. 296-310Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

One of the main challenges with the Homogeneous Charge Compression Ignition, HCCI, combustion system is to control the Start Of Combustion, SOC, for varying load and external conditions. A method to achieve this on a cycle-by-cycle basis is to vary the valve timing based on a feedback signal from the SOC of previous cycles. The control can be achieved with two basic valve-timing strategies named the Overlap- and the IVC-method. The Overlap-method works by trapping of residuals while the IVC-method affects the effective compression ratio. In an earlier paper it has been shown that if the two methods are incorporated into one controller, SOC can be controlled in a relatively large operating window although the transient performance was not sufficient. The reason is that the simple PI-controller cannot be made fast enough to cope with the transients without magnifying the cycle-to-cycle variations of the combustion into instability. In this work a model based control system that features a non-linear compensation, based on the inverse of the non-linear function from valve timings to ignition delay, is suggested and evaluated. The results show good transient performance. Control performance from engine tests is reported. A combined engine and control simulation system is used for the development of the control strategies. The simulations are accomplished with a commercial cycle simulation code linked with a commercial control simulation code. The simulations are iteratively verified against engine test data. Engine tests are conducted on a single cylinder engine equipped with a hydraulic valve system.

Ort, förlag, år, upplaga, sidor
2005. Vol. 114, nr 3, s. 296-310
Nationell ämneskategori
Teknik och teknologier
Identifikatorer
URN: urn:nbn:se:kth:diva-6042DOI: 10.4271/2005-01-0131Scopus ID: 2-s2.0-84877490120OAI: oai:DiVA.org:kth-6042DiVA, id: diva2:10626
Anmärkning

QC 20100629

Tillgänglig från: 2006-08-09 Skapad: 2006-08-09 Senast uppdaterad: 2014-08-08Bibliografiskt granskad
Ingår i avhandling
1. Control of HCCI by aid of Variable Valve Timings with Specialization in Usage of a Non-Linear Quasi-Static Compensation
Öppna denna publikation i ny flik eller fönster >>Control of HCCI by aid of Variable Valve Timings with Specialization in Usage of a Non-Linear Quasi-Static Compensation
2006 (Engelska)Doktorsavhandling, sammanläggning (Övrigt vetenskapligt)
Abstract [en]

This doctoral thesis is about controlling the combustion timing of the combustion concept Homogeneous Charge Compression Ignition, HCCI, by means of variable valve timings.

The HCCI research usually is regarded to have started in Japan during the later part of the 1970´s. The world of HCCI has since grown and HCCI is of today researched worldwide. Of particular interest from a Swedish point of view is that Lund Institute of Technology has emerged as one of the world leading HCCI laboratories.

The idea with HCCI is to combine the Otto and Diesel engine. As in an Otto engine the charge is premixed but as in a Diesel engine the operation is unthrottled and the compression heat causes the ignition. The combustion that follows the ignition takes place homogeneously and overall lean. The result is ultra low NOx and particulate emissions combined with high total efficiency. A difficulty with the HCCI-concept is that it only works in a narrow area and that there is no direct way to control the Start Of Combustion, SOC. Out of this follows that timing/phasing of the combustion is one of the main difficulties with HCCI combustion concepts. This is particularly emphasized during transient operation and calls for feedback control of the combustion timing.

This work investigates one method, the variable valve timing, to achieve feedback control of the combustion phasing. From the work it can be concluded that the variable valve timing can control the combustion phasing during engine transients. In order to improve the performance a non-linear compensation from ignition delay to valve timings has been suggested, incorporated in a control structure and tested in engine test. The engine test has been performed in a single cylinder engine based on a Scania truck engine. The speed range from 500 to 1750 rpm and the load range 1.26 and 10.5 bar of netIMEP has been covered with fair transient performance.

Ort, förlag, år, upplaga, sidor
Stockholm: KTH, 2006
Serie
Trita-MMK, ISSN 1400-1179 ; 2006:06
Nyckelord
HCCI, Homogeneous, Charge Compression Ignition, Engine Control, Variable Valve Timings
Nationell ämneskategori
Övrig annan teknik
Identifikatorer
urn:nbn:se:kth:diva-4070 (URN)
Disputation
2006-09-04, F3, KTH, Lindstedsvägen 26, Stockholm, 14:00
Opponent
Handledare
Anmärkning
QC 20100629Tillgänglig från: 2006-08-09 Skapad: 2006-08-09 Senast uppdaterad: 2010-06-29Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Övriga länkar

Förlagets fulltextScopus

Personposter BETA

Wikander, Jan

Sök vidare i DiVA

Av författaren/redaktören
Agrell, FredrikÅngström, Hans-ErikWikander, JanLinderyd, Johan
Av organisationen
Maskinkonstruktion (Avd.)
Teknik och teknologier

Sök vidare utanför DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 401 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf