Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Modelling of effects of ultrastructural morphology on the hygroelastic properties of wood fibres
KTH, Skolan för teknikvetenskap (SCI), Hållfasthetslära (Inst.).
2007 (engelsk)Inngår i: Journal of Materials Science, ISSN 0022-2461, E-ISSN 1573-4803, Vol. 42, nr 24, s. 10254-10274Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

Wood fibres constitute the structural framework of e.g. wood, paper, board and composites, where stiffness and dimensional stability are of importance. An analytical modelling approach has been used for prediction of hygroelastic response, and assessment of the stresses in thick-walled cylinder models of wood fibres. A wood fibre was idealised as a multilayered hollow cylinder made of orthotropic material with helical orientation. The hygroelastic response of the layered assembly due to axisymmetric loading and moisture content changes was obtained by solving the corresponding boundary value problem of elasticity. A simple solution scheme based on the state space approach and the transfer matrix method was employed. This was combined with an analytical ultrastructural homogenisation method, used to link hygroelastic properties of constituent wood polymers to properties of each layer. Predicted hygroelastic response captured experimentally measured behaviour. Fibres that were constrained not to twist showed a stiffer response than fibres allowed twisting under uniaxial loading. It was also shown that the ultrastructure, i.e. the microfibril angle, will control the hygroexpansion in the same way as it controls the compliance of the cell wall. Qualitative failure trends comparable with experimental observations could be established with stress analysis and a simple plane-stress failure criterion.

sted, utgiver, år, opplag, sider
2007. Vol. 42, nr 24, s. 10254-10274
Emneord [en]
norway spruce tracheids, carbon nanotube arrays, state-space formalism, southern pine fibers, mechanical-properties, cell-wall, composite-materials, moisture-content, elastic-modulus, part i
HSV kategori
Identifikatorer
URN: urn:nbn:se:kth:diva-6100DOI: 10.1007/s10853-006-1199-9ISI: 000249980100050Scopus ID: 2-s2.0-35148830728OAI: oai:DiVA.org:kth-6100DiVA, id: diva2:10714
Merknad
Uppdaterad från manuskript till artikel: 20100914 QC 20100914Tilgjengelig fra: 2006-09-12 Laget: 2006-09-12 Sist oppdatert: 2017-12-14bibliografisk kontrollert
Inngår i avhandling
1. Hygroelastic behaviour of wood-fibre based materials on the composite, fibre and ultrastructural level
Åpne denne publikasjonen i ny fane eller vindu >>Hygroelastic behaviour of wood-fibre based materials on the composite, fibre and ultrastructural level
2006 (engelsk)Doktoravhandling, med artikler (Annet vitenskapelig)
Abstract [en]

Wood fibres can be used as reinforcement in plastics for load carrying purposes. Some advantages compared with conventional man-made fibres are that wood fibres come from a renewable resource, have high specific stiffness and strength, are generally less hazardous to health, biodegradable, and can be manufactured at low cost and high volumes. A clear disadvantage with cellulose-based materials for structural use is their dimensional instability in humid environments. The hygroelastic properties are of high importance in materials development of improved wood-fibre composites. This work deals with the stiffness and hygroexpansion of wood fibres for composite materials. The long-term aim is to design engineered wood fibre composites based on better basic knowledge of wood fibres.

Mechanistic models have been used to link the fibrous microstructure with macroscopic composite engineering properties. The properties have been characterized experimentally for various wood-fibre composites and their fibre-mat preforms, by means of curvature measurements at various levels of relative humidity, as well as tensile and compressive tests. From these test results and microstructural characterization, the longitudinal Young’s modulus and transverse coefficient of hygroexpansion of wood fibres were identified by inverse modelling. Some effects of various pulp processes and fibre modifications on the elastic properties of the fibre were observed, illustrating how the mixed experimental-modelling approaches can be used in more efficient materials screening and selection.

An improved micromechanical analysis for wood-fibre composites has been presented. The model is more appropriate to combine with laminate analogy, to link fibre properties on the microscale to the macroscopic composite properties and vice versa. It also offers the possibility to include the effects of ultrastructure since it can account for an arbitrary number of phases. An approach to model ultrastructure-fibre property relations has been demonstrated. It includes analytical modelling of multilayered cylindrical fibres as well as finite element modelling of fibres with irregular geometry characterized with microscopy. Both approaches are useful and could be combined with experiments to reveal insights that can pave way for a firmer link between the wood fibre ultrastructure and wood fibre properties.

sted, utgiver, år, opplag, sider
Stockholm: KTH, 2006. s. xiii, 31
Serie
Trita-HFL. Rapport/ Institutionen för hållfasthetslära, KTH, ISSN 1654-1472 ; 0414
Emneord
wood fibres, ultrastructure, structure-property relations, microfibril angle, composites, characterization methods, hygroelastic properties, micromechanics, modelling, reinforcement potential
HSV kategori
Identifikatorer
urn:nbn:se:kth:diva-4098 (URN)
Disputas
2006-09-29, E2, Lindstedsvägen 3, Stockholm, 10:00
Opponent
Veileder
Merknad

QC 20100914

Tilgjengelig fra: 2006-09-12 Laget: 2006-09-12 Sist oppdatert: 2013-01-14bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekstScopus

Søk i DiVA

Av forfatter/redaktør
Neagu, Cristian R.Gamstedt, Kristofer E.
Av organisasjonen
I samme tidsskrift
Journal of Materials Science

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 251 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf