Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Inception of first mode negative streamers at liquid/solid interfaces
KTH, Skolan för elektro- och systemteknik (EES), Elektroteknisk teori och konstruktion.ORCID-id: 0000-0002-4800-9990
KTH, Skolan för elektro- och systemteknik (EES), Elektroteknisk teori och konstruktion.ORCID-id: 0000-0002-6375-6142
KTH, Skolan för kemivetenskap (CHE), Fiber- och polymerteknologi.ORCID-id: 0000-0002-1924-6954
KTH, Skolan för kemivetenskap (CHE), Fiber- och polymerteknologi.ORCID-id: 0000-0001-8622-0386
(Engelska)Ingår i: Journal of Physics D: Applied PhysicsArtikel i tidskrift, Editorial material (Refereegranskat) Submitted
Abstract [en]

This paper presents an experimental study on the inception of first mode negative streamers at different mineral-oil/solid interfaces. This study is performed with a point-plane configuration immersed in mineral oil (point cathode). The mineral-oil/solid interface is done by assembling a solid in an inclined position into the point-plane gap. The solid is in contact (or in the proximity) with the point electrode tip. The tested solids are a kraft paper, a paper made from cellulosic micro and nano fibrils and different polymeric films (low density polyethylene (LDPE), polyethylene terephthalate (PET), polytetrafluoroethylene (PTFE) and polyvinylidene fluoride (PVDF)). These solids have different relative permittivity and structural composition. It is found that the streamer inception voltage is statistically similar for the cases with solids with higher permittivity than mineral oil. The streamer inception voltage for the case without any solid barrier is also statistically similar to the cases with solids with higher permittivity than mineral oil. It is also found that the inception voltage is higher for streamers initiated at permittivity-matched interfaces (cases with LDPE and PTFE). Additionally, the influence of the spatial limitation with the solid surface to the volume where the streamer initiation process takes is performed with PTFE by varying the distance between the point electrode and the solid surface. It is shown that the streamer inception voltage depends on the distance between the point electrode and the solid surface. Furthermore, It is observed that the streamer inception voltage is also influenced when the distance between the point electrode and the surface of the PTFE is several micrometers (twenty times longer than the penetration depth of the avalanche responsible of streamer initiation). Additionally, it is also shown that a recently-proposed streamer inception criterion is unsuitable to predict the streamer inception conditions close to permittivity matched and mismatched liquid/solid interfaces.

Nationell ämneskategori
Teknik och teknologier
Identifikatorer
URN: urn:nbn:se:kth:diva-213421OAI: oai:DiVA.org:kth-213421DiVA, id: diva2:1137247
Anmärkning

QC 20170901

Tillgänglig från: 2017-08-30 Skapad: 2017-08-30 Senast uppdaterad: 2017-09-01Bibliografiskt granskad
Ingår i avhandling
1. On the inception and propagation of streamers along mineral-oil/solid interfaces
Öppna denna publikation i ny flik eller fönster >>On the inception and propagation of streamers along mineral-oil/solid interfaces
2017 (Engelska)Doktorsavhandling, sammanläggning (Övrigt vetenskapligt)
Abstract [en]

This thesis presents an experimental study of positive and negativestreamers propagating along mineral-oil/solid interfaces under square highvoltage pulses. The thesis includes the design and construction of anexperimental setup to studying the streamers in a point-plane configurationcapable to detect streamer parameters such as velocity, length, propagationtime, emitted light and charge.The first part of this experimental study is devoted to the analysis of thestreamer inception at mineral-oil/solid interfaces under negative polarity. Thestreamer inception voltage and charge recordings are reported for eachmineral-oil/solid interface. It is found that only solids with a permittivitysimilar to that of mineral oil can influence the streamer inception voltage.Solids with matched permittivity such as LDPE and PTFE increase the inceptionvoltage. The cases with solids with higher permittivity than mineral oil havesimilar inception voltage as the streamer incepted in the liquid bulk withoutsolid. The second part is devoted to studying the propagation of first mode negativestreamers along different mineral-oil/solid interfaces. A comparison of theelectrical and physical properties of the streamers (e.g. charge, length,velocity, etc.) is presented. Solid samples with different chemical compositionand different physical properties are used. The solid samples are anoil-impregnated kraft paper and an low-porosity paper referred to as kraftfibril paper made from cellulosic micro and nano fibrils. Polymeric films madeof low density polyethylene (LDPE), polyethylene terephthalate (PET),polytetrafluoroethylene (PTFE) and polyvinylidene fluoride (PVDF) are also usedas the solid. Streamers propagating along the liquid/solid interface arecompared with streamers developing in mineral oil without solid. Streamerspropagate longer and faster along solids with low surface roughness, lowporosity and higher electrical permittivity than mineral oil showing aquasi-continuous injection of charge in the early stage of propagation.The third part of the experimental study deals with second mode positivestreamers propagating along mineral-oil/solid interfaces. The inception andpropagation of the streamer are investigated using different mineral-oil/solidinterfaces. Measurements of the streamer velocity, charge, stopping length,propagation time, together with light recordings and shadowgraphs are reported.It is found that the interface can influence the streamer inception voltage,branching, stopping length, velocity, charge and current. Properties of thesolid and of the interface (i.e. surface roughness, permittivity, wettability)are parameters that influence the streamer propagation.

Ort, förlag, år, upplaga, sidor
KTH Royal Institute of Technology, 2017. s. 74
Nationell ämneskategori
Teknik och teknologier
Identifikatorer
urn:nbn:se:kth:diva-213426 (URN)978-91-7729-397-2 (ISBN)
Disputation
2017-09-15, V2, Teknikringen 76, Stockholm, 10:00 (Engelska)
Opponent
Handledare
Anmärkning

QC 20170901

Tillgänglig från: 2017-09-01 Skapad: 2017-08-30 Senast uppdaterad: 2017-09-04Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Sök vidare i DiVA

Av författaren/redaktören
Ariza, DavidBecerra, MarleyHollertz, RebeccaWågberg, Lars
Av organisationen
Elektroteknisk teori och konstruktionFiber- och polymerteknologi
Teknik och teknologier

Sök vidare utanför DiVA

GoogleGoogle Scholar

urn-nbn

Altmetricpoäng

urn-nbn
Totalt: 1173 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf