Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Experiments on the Onset of Impacting Motion Using a Pipe Conveying Fluid
KTH, Tidigare Institutioner                               , Mekanik.
KTH, Tidigare Institutioner                               , Flygteknik.
KTH, Tidigare Institutioner                               , Mekanik.
1999 (engelsk)Inngår i: Nonlinear dynamics, ISSN 0924-090X, E-ISSN 1573-269X, Vol. 19, nr 3, s. 261-271Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

The transition from stable periodic nonimpacting motion to impacting motion, due to variations of parameters, is observable in a wide range of vibro-impact systems. Recent theoretical studies suggest a possible scenario for this type of transition. A key element in the proposed scenario is fulfilled if the oscillatory motion involved in the transition is born in a supercritical Hopf bifurcation. If the onset of impacting motion is close to the Hopf bifurcation, the impacting motion is likely to be chaotic. A numerical simulation of a system of articulated pipes conveying fluid is used to illuminate the theory. An experimental setup is presented, where a cantilevered pipe conveying fluid is unilaterally constrained. Results from experiments are found to be in good qualitative agreement with the theory.

sted, utgiver, år, opplag, sider
1999. Vol. 19, nr 3, s. 261-271
Emneord [en]
grazing bifurcation, impact oscillations, pipe conveying fluid, Hopf bifurcation
HSV kategori
Identifikatorer
URN: urn:nbn:se:kth:diva-12427DOI: 10.1023/A:1008322725617ISI: 000081414500003Scopus ID: 2-s2.0-0032675560OAI: oai:DiVA.org:kth-12427DiVA, id: diva2:311372
Merknad
QC 20100421Tilgjengelig fra: 2010-04-21 Laget: 2010-04-21 Sist oppdatert: 2020-03-10bibliografisk kontrollert
Inngår i avhandling
1. Control and optimization of structures with fluid interaction
Åpne denne publikasjonen i ny fane eller vindu >>Control and optimization of structures with fluid interaction
2000 (engelsk)Doktoravhandling, med artikler (Annet vitenskapelig)
Abstract [en]

Various problems on the optimal design of elastic structures subject to nonconservative fluid-dynamic forces are considered. The optimal design problem istypically posed as minimizing structural weight subject to constraints on structural stability. Traditionally, structural dimensions and orientations of fibercomposite materials are common design variables. It is demonstrated that the structural weight can be reduced further by including the design of a stabilizingcontrol system in the structural design optimization, giving an integrated optimization problem where both structural and control system parameters are used as design variables. The integrated approach may result in a design with significantly improved performance compared to traditional methods, both in terms of reduced structural weight and control system performance. Using optimization for design of mechanical systems with nonconservative external load tends to increase the likelihood of obtaining a design which is very sensitive to imperfections. As a result, the predicted performance of the optimal design may not be achieved in practice. The importance of this fundamental difficulty is emphasized throughout the thesis by comparing numerically obtained results to experiments.

The first part of the thesis is concerned with the stability and optimal design of a beam subject to forces induced by fluid flow through attached pipes. A nozzle control system deflecting the fluid jet at the beam tip is used to improve the stability of the system. The simultaneous design of the control system and the beam shape minimizing structural mass is performed using numerical optimization. The inclusion of the control system in the optimization gives a considerable reduction of the beam weight but results in an optimal design which is very sensitive to imperfections. An optimal design with improved robustness is obtained by solving a modified optimization problem. The stability of a flexible wing structure with a controllable trailing edge flap is investigated. Due to uncertainties in the numerical stability analysis, the wing is predicted to become unstable at a significantly higher speed than what is observed in wind tunnel tests. Two different approaches to stabilize the wing in flutter is demonstrated. First, numerical optimization is used to design a controller which at each flow speed maximizes the damping of the flutter mode observed in the wind tunnel experiment. Second, an integrated approach is adopted, where a simultaneous mass balancing and control law design is performed. It is argued that a two-step procedure may be required to obtain a design with minimum weight and a control law that is well-defined for all operating conditions.

sted, utgiver, år, opplag, sider
Stockholm: KTH, 2000. s. 8
Serie
Report. Department of Aeronautics ; 2000:1
Identifikatorer
urn:nbn:se:kth:diva-2956 (URN)993-261067-4 (ISBN)
Disputas
2000-05-12, 00:00 (engelsk)
Merknad
QC 20100421 NR 20140805Tilgjengelig fra: 2000-05-11 Laget: 2000-05-11 Sist oppdatert: 2010-04-28bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekstScopus

Søk i DiVA

Av forfatter/redaktør
Fredriksson, Mats H.Borglund, DanNordmark, Arne B.
Av organisasjonen
I samme tidsskrift
Nonlinear dynamics

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 241 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf