Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
A thermodynamic study of silicon containing gas around a blast furnace raceway
KTH, Skolan för industriell teknik och management (ITM), Materialvetenskap, Tillämpad processmetallurgi.
KTH, Skolan för industriell teknik och management (ITM), Materialvetenskap, Tillämpad processmetallurgi.
KTH, Skolan för industriell teknik och management (ITM), Materialvetenskap, Tillämpad processmetallurgi.
2005 (Engelska)Ingår i: ISIJ International, ISSN 0915-1559, E-ISSN 1347-5460, Vol. 45, nr 5, s. 662-668Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

The equilibrium conditions for silicon transfer from ash to the liquid metal phase via SiO gas have been discussed by several authors. However, no published calculations have been found using the most modern thermodynamic models available. Since there are major differences in the results of calculations using different thermodynamic models and the models are continuously being improved, new equilibrium calculations on SiO and SiS gas formation have been performed using the recently developed models. Different ingoing compositions of coke ash, coal powder ash and blast air were used in the calculations. The compositions chosen represent blast furnace no. 3 at SSAB in Lulea, Sweden. Temperature was found to be the major factor influencing the equilibrium silicon level in the gas phase. At low temperatures (below 1 600 degrees C the total gas pressure was also seen to influence the silicon content in the gas phase. The main reason for this is that below 1 600 degrees C, the amount of liquid slag at equilibrium increases with the total gas pressure. Liquid slag contains large amounts of silica that then can not be found in the gas phase. Higher carbon activity is usually expected to result in higher SiO gas levels in the blast furnace. The equilibrium calculations show that increased carbon activity increases the amount of silicon in the gas phase at temperatures up to about 1 600 degrees C, but that at higher temperatures SiC is formed that decreases the equilibrium silicon level in the gas phase.

Ort, förlag, år, upplaga, sidor
2005. Vol. 45, nr 5, s. 662-668
Nyckelord [en]
ironmaking, blast furnace chemistry, thermodynamics, calculation, slags, cast iron, gases, silicon compounds
Nationell ämneskategori
Metallurgi och metalliska material
Identifikatorer
URN: urn:nbn:se:kth:diva-38229DOI: 10.2355/isijinternational.45.662ISI: 000229310700006Scopus ID: 2-s2.0-22544441892OAI: oai:DiVA.org:kth-38229DiVA, id: diva2:436316
Anmärkning

QC 20110823

Tillgänglig från: 2011-08-23 Skapad: 2011-08-23 Senast uppdaterad: 2017-12-08Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Övriga länkar

Förlagets fulltextScopus

Sök vidare i DiVA

Av författaren/redaktören
Gustavsson, JoelAndersson, Margareta A.T.Jönsson, Pär
Av organisationen
Tillämpad processmetallurgi
I samma tidskrift
ISIJ International
Metallurgi och metalliska material

Sök vidare utanför DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 71 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf