Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Influence of water vapour and tar compound on combustion of simulated gasified biomass
KTH, Skolan för industriell teknik och management (ITM), Energiteknik, Kraft- och värmeteknologi.
KTH, Skolan för industriell teknik och management (ITM), Energiteknik, Kraft- och värmeteknologi.
KTH, Skolan för industriell teknik och management (ITM), Energiteknik, Kraft- och värmeteknologi.
(Engelska)Ingår i: Fuel, ISSN 0016-2361, E-ISSN 1873-7153Artikel i tidskrift (Övrigt vetenskapligt) Submitted
Abstract [en]

Gasification is a thermo‐chemical process which converts biomass fuel into a gaseous mixture, gasified biomass, which can be used in various prime movers. For heat and power generation, using gasified biomass in a combustion device, for example, can give lower undesired emission compared to direct combustion of solid biomass. However, with regards to its variety in composition and lower heating value, the combustion behaviour of gasified biomass may differ from natural gas. The main objective of this study is to investigate the influence of water and tar compound on the combustion of simulated gasified biomass, which mainly contains CO, H2, CH4, CO2, N2. The combustion tests are conducted at atmospheric pressure in a premixed combustor. At a fixed input thermal load, CO and NOx emission levels, combustion temperature, and blowoff characteristics of gasified biomass are observed while varying the volume fraction of water (H2O) or benzene (C6H6) vapours in the fuel mixture. With low H2O level in the fuel mixture, the combustion temperature is almost constant, while NOx emission is decreased compared to dry gasified biomass. On the contrary, the combustion temperature decreases and NOx emission is almost constant at higher H2O content. A temperature limit was observed where CO emission could be maintained at low concentration. The blowoff limit was shifted to higher equivalence ratio. The blowoff temperature was first slightly decreased at lower H2O level and raised when H2O level is further increased. With the content of C6H6, the combustion temperature and NOx emission enhanced, while CO emission was reduced. The blowoff occurs at slightly higher equivalence ratio and temperature compared to gasified biomass without C6H6. The study shows that the presence of H2O and C6H6 in gasified biomass may give positive effects on the emission characteristics during combustion, but also that there are limits for these effects.

Nyckelord [en]
Gasified biomass; water vapour; benzene vapour; CO, UHC, NOx emissions; blowoff
Nationell ämneskategori
Energiteknik
Identifikatorer
URN: urn:nbn:se:kth:diva-120573OAI: oai:DiVA.org:kth-120573DiVA, id: diva2:615587
Anmärkning

QS 2013

Tillgänglig från: 2013-04-11 Skapad: 2013-04-11 Senast uppdaterad: 2017-12-06Bibliografiskt granskad
Ingår i avhandling
1. Combustion of gasified biomass:: Experimental investigation on laminar flame speed, lean blowoff limit and emission levels
Öppna denna publikation i ny flik eller fönster >>Combustion of gasified biomass:: Experimental investigation on laminar flame speed, lean blowoff limit and emission levels
2013 (Engelska)Doktorsavhandling, sammanläggning (Övrigt vetenskapligt)
Abstract [en]

Biomass is among the primary alternative energy sources that supplements the fossil fuels to meet today’s energy demand. Gasification is an efficient and environmental friendly technology for converting the energy content in the biomass into a combustible gas mixture, which can be used in various applications. The composition of this gas mixture varies greatly depending on the gasification agent, gasifier design and its operation parameters and can be classified as low and medium LHV gasified biomass. The wide range of possible gas composition between each of these classes and even within each class itself can be a challenge in the combustion for heat and/or power production. The difficulty is primarily associated with the range in the combustion properties that may affect the stability and the emission levels. Therefore, this thesis is intended to provide data of combustion properties for improving the operation or design of atmospheric combustion devices operated with such gas mixtures.

The first part of this thesis presents a series of experimental work on combustion of low LHV gasified biomass (a simulated gas mixture of CO/H2/CH4/CO2/N2) with variation in the content of H2O and tar compound (simulated by C6H6). The laminar flame speed, lean blowoff limit and emission levels of low LHV gasified biomass based on the premixed combustion concept are reported in paper I and III. The results show that the presence of H2O and C6H6 in gasified biomass can give positive effects on these combustion parameters (laminar flame speed, lean blowoff limit and emission levels), but also that there are limits for these effects. Addition of a low percentage of H2O in the gasified biomass resulted in almost constant laminar flame speed and combustion temperature of the gas mixture, while its NOx emission and blowoff temperature were decreased. The opposite condition was found when H2O content was further increased. The blowoff limit was shifted to richer fuel equivalence ratio as H2O increased. A temperature limit was observed where CO emission could be maintained at low concentration. With C6H6 addition, the laminar flame speed first decreased, achieved a minimum value, and then increased with further addition of C6H6. The combustion temperature and NOx emission were increased, CO emission was reduced, and blowoff occurs at slightly higher equivalence ratio and temperature when C6H6 content is increased. The comparison with natural gas (simulated by CH4) is also made as can be found in paper I and II. Lower laminar flame speed, combustion temperature, slightly higher CO emission, lower NOx emission and leaner blowoff limit were obtained for low LHV gas mixture in comparison to natural gas.

In the second part of the thesis, the focus is put on the combustion of a wide range of gasified biomass types, ranging from low to medium LHV gas mixture (paper IV). The correlation between laminar flame speed or lean blowoff limit and the composition of various gas mixtures was investigated (paper IV). It was found that H2 and content of diluents have higher influence on the laminar flame speed of the gas mixture compared to its CO and hydrocarbon contents. For lean blowoff limit, the diluents have the greatest impact followed by H2 and CO. The mathematical correlations derived from the study can be used to for models of these two combustion parameters for a wide range of gasified biomass fuel compositions.

Ort, förlag, år, upplaga, sidor
Stockholm: KTH Royal Institute of Technology, 2013. s. 81
Serie
TRITA-KRV, ISSN 1100-7990 ; 13:03
Nyckelord
biomass gasification; gasified biomass; laminar flame speed; blowoff; emissions
Nationell ämneskategori
Energiteknik
Identifikatorer
urn:nbn:se:kth:diva-120570 (URN)978-91-7501-710-5 (ISBN)
Disputation
2013-04-22, M3, Brinellvägen 64, KTH, Stockholm, 10:00 (Engelska)
Opponent
Handledare
Anmärkning

QC 20130411

Tillgänglig från: 2013-04-11 Skapad: 2013-04-11 Senast uppdaterad: 2014-01-16Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Sök vidare i DiVA

Av författaren/redaktören
Binti Munajat, Nur FarizanErlich, CatharinaFransson, Torsten H.
Av organisationen
Kraft- och värmeteknologi
I samma tidskrift
Fuel
Energiteknik

Sök vidare utanför DiVA

GoogleGoogle Scholar

urn-nbn

Altmetricpoäng

urn-nbn
Totalt: 127 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf