Change search
ReferencesLink to record
Permanent link

Direct link
Total refraction of p-polarized light at the 90-degree domain boundary in the ferroelectric crystal
KTH, Superseded Departments, Physics.
2004 (English)In: Japanese Journal of Applied Physics, ISSN 0021-4922, E-ISSN 1347-4065, Vol. 43, no 6A, 3413-3418 p.Article in journal (Refereed) Published
Abstract [en]

A 90.DEG.-domain structure was fabricated using electrical poling in ferroelectric birefringent KNbO3 crystal. The refraction and reflection characteristics of the light at the boundary of the 90.DEG.-domain structure were investigated, and the novel behavior of total refraction (no reflection) has been found for the P-polarized light throughout the entire range of incident angle (0.LEQ..THETA..LEQ.90.DEG.). Strong refraction of the light was observed after it exited from the crystal output surface at the incidence parallel to the domain boundary. These behaviors were explained analytically. (author abst.)

Place, publisher, year, edition, pages
2004. Vol. 43, no 6A, 3413-3418 p.
National Category
Physical Sciences
URN: urn:nbn:se:kth:diva-6114DOI: 10.1143/JJAP.43.3413ISI: 000222503400030OAI: diva2:10732
QC 20110211Available from: 2006-09-14 Created: 2006-09-14 Last updated: 2011-02-11Bibliographically approved
In thesis
1. Characterization of domain switching and optical damage properties in ferroelectrics
Open this publication in new window or tab >>Characterization of domain switching and optical damage properties in ferroelectrics
2006 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Nonlinear optical frequency conversion is one of the most important key techniques in order to obtain lasers with wavelengths targeted for specific applications. In order to realize efficient and tailored lasers, the quasi-phase-matching (QPM) approach using periodically-poled ferroelectric crystals is getting increasingly important. Also understanding of damage mechanisms in nonlinear materials is necessary to be able to design reliable and well working lasers. This is especially true for high power application lasers, which is a rapidly growing field, where the damage problem normally is the ultimate limiting factor.

In this thesis work, several promising novel ferroelectric materials have been investigated for nonlinear optical applications and the emphasis has been put on QPM devices consisting of periodically-poled structures. The materials were selected from three different types of ferroelectric materials: 1) MgO-doped stoichiometric LiNbO3 (MgO:SLN) and LiTaO3 (MgO:SLT), and non-doped stoichiometric LiTaO3 (SLT), 2) KTiOPO4 (KTP) and its isomorphs RbTiOPO4 (RTP), and 3) KNbO3 (KN). The focus in our investigations have been put on the spontaneous polarization switching phenomena, optimization of the periodic poling conditions, and the photochromic optical damage properties which were characterized by the help of blue light-induced infrared absorption (BLIIRA) measurements.

With electrical studies of the spontaneous polarization switching, we were able to determine quantitatively, and compare, the coercive field values of different materials by applying triangularly shaped electric fields. We found that the values of the coercive fields depended on the increase rate of the applied electric field. The coercive field of KN was the lowest (less than 0.5 kV/mm) followed by the ones of KTP, SLT, and MgO:SLT (1.5 to 2.5 kV/mm). MgO:SLN, and RTP had relatively high coercive fields, approximately 5.0 to 6.0 kV/mm, respectively. Based on the domain switching characteristics we found, we successfully fabricated periodically-poled devices in all of the investigated materials with 30 μm periodicities and sample thickness of 1 mm.

Blue light-induced infrared absorption (BLIIRA) has been characterized for unpoled bulk and periodically-poled samples using a high-sensitivity, thermal-lens spectroscopy technique. SLT showed a large photorefraction effect and the BLIIRA signal could not be properly measured because of the large distortion of the probe beam. The rise and relaxation time of BLIIRA, after switching the blue light on and off was in a time span of 10 to 30 sec except for KTP and its isomorphs, which needed minutes to hours in order to saturate at a fixed value. KN and MgO:SLN showed the lowest susceptibility to the induced absorption. Periodic poling slightly increased the susceptibility of KTP, MgO:SLT, and KN. Relatively high thresholds were observed in MgO:SLT and KN. By increasing the peak-power intensity of the blue light, the induced absorption for MgO:SLN, KTP and KN saturated at a constant value while that of MgO:SLT increase in a constant fashion. This trend is critical issue for the device reliability at high-power applications.

Place, publisher, year, edition, pages
Stockholm: KTH, 2006. 100 p.
Trita-FYS, ISSN 0280-316X ; 2006:59
quasi-phase matching, ferroelectric domains, stoichiometric LiNbO3, stoichiometric LiTaO3, KTiOPO4, KNbO3, polarization switching, periodic electric field poling, optical damages
National Category
Atom and Molecular Physics and Optics
urn:nbn:se:kth:diva-4100 (URN)91-7178-443-8 (ISBN)
Public defence
2006-09-26, Sal FB54, AobaNova univ. centrum, Roslagstullsbacken 21, Stockholm, 10:00 (English)
QC 20100830Available from: 2006-09-14 Created: 2006-09-14 Last updated: 2015-03-30Bibliographically approved

Open Access in DiVA

No full text

Other links

Publisher's full text

Search in DiVA

By author/editor
Hirohashi, Junji
By organisation
In the same journal
Japanese Journal of Applied Physics
Physical Sciences

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 47 hits
ReferencesLink to record
Permanent link

Direct link