Change search
ReferencesLink to record
Permanent link

Direct link
Modeling and testing of line start permanent magnet motors
KTH, School of Electrical Engineering (EES).ORCID iD: 0000-0003-3455-9067
2007 (English)Licentiate thesis, monograph (Other scientific)
Abstract [en]

This licentiate thesis describes the modeling and measurements performed with the aim of developing design guidelines for Line Start Permanent Magnet Synchronous Motors, LSPMSMs. LSPMSMs can offer higher efficiency than standard induction motors used in the industry today, especially for small motor sizes. The increase in efficiency results in lower environmental impact and reduced electricity cost. The LSPMSM has, however, several drawbacks, among the most important is the reduced starting capability compared to induction motors. Furthermore, the rotor construction is complex and the added cost of magnet material makes the LSPMSM a comparably expensive motor type. The design of a LSPMSM is a trade-off between starting capability and steady state performance. The thesis discusses these trade-offs and the models that can be used as a basis for design and optimization. The models make use of different motor parameters, and a number of measurement methods for measuring these parameters are described and compared. Among these is a step response adapted measurement method that provides most of the parameters of interest. The development and setup of a brake bench for measuring both start-up and steady state performance is presented. Furthermore the start-up behavior and steady-state performance is calculated using measured parameters. The calculated performance is compared to measured performance and found to correlate well for nominal operating conditions. Thus, design guidelines can be based on the models proposed.

Place, publisher, year, edition, pages
Stockholm: KTH , 2007. , 100 s. p.
Trita-EE, ISSN 1653-5146 ; 2007:049
Keyword [en]
line start permanent magnet, flux integration, step response
National Category
Other Electrical Engineering, Electronic Engineering, Information Engineering
URN: urn:nbn:se:kth:diva-4488ISBN: 978-91-7178-749-1OAI: diva2:12509
2007-09-28, H1, KTH, Teknikringen 33, Stockholm, 10:15
QC 20101112Available from: 2007-09-18 Created: 2007-09-18 Last updated: 2010-11-12Bibliographically approved

Open Access in DiVA

fulltext(1082 kB)4577 downloads
File information
File name FULLTEXT01.pdfFile size 1082 kBChecksum MD5
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Modeer, Tomas
By organisation
School of Electrical Engineering (EES)
Other Electrical Engineering, Electronic Engineering, Information Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 4577 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 793 hits
ReferencesLink to record
Permanent link

Direct link