Change search
ReferencesLink to record
Permanent link

Direct link
The importance of the experimental method when evaluating the quality of fines of mechanical pulps
2000 (English)In: Journal of Pulp and Paper Science (JPPS), ISSN 0826-6220, Vol. 26, no 9, 301-307 p.Article in journal (Refereed) Published
Abstract [en]

Changes in properties of TMP fines brought about by the method of fractionation were investigated. Fines fractionated from white water by Baller McNett showed a higher tensile index and a lower light absorption compared with fines obtained using a Britt dynamic drainage jar (BDDJ). This was attributed to the large volume of tap water and thus more extensive washing of the fines in the Bauer McNett. This was strongly supported by the fact that acetone extraction improved the strength properties of these fines drastically. Fines fractionated from a fresh TMP by the Bauer McNett had a stronger light absorption and lower light scattering than those obtained by the BDDJ. This was attributed to the use of tap water and the loss of small particles in the Bauer McNett. Since the washing of mechanical pulp influences the properties significantly, the BDDJ method is recommended because it uses less water and of a more defined quality than does the Bauer McNett.

Place, publisher, year, edition, pages
2000. Vol. 26, no 9, 301-307 p.
Keyword [en]
thermomechanical pulps, fines, pulp properties, washing, fiber classification, mechanical properties
URN: urn:nbn:se:kth:diva-20046ISI: 000089408400001OAI: diva2:338739
QC 20100525Available from: 2010-08-10 Created: 2010-08-10Bibliographically approved

Open Access in DiVA

No full text

Search in DiVA

By author/editor
Wågberg, Lars
In the same journal
Journal of Pulp and Paper Science (JPPS)

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 26 hits
ReferencesLink to record
Permanent link

Direct link