A finite element-based model of normal contact between rough surfaces
2003 (English)In: Wear, ISSN 0043-1648, E-ISSN 1873-2577, Vol. 254, no 11, 1180-1188 p.Article in journal (Refereed) Published
Engineering surfaces can be characterized as more or less randomly rough. Contact between engineering surfaces is thus discontinuous and the real area of contact is a small fraction of the nominal contact area. The stiffness of a rough surface layer thus influences the contact state as well as the behavior of the surrounding system. A contact model that takes the properties of engineering surfaces into account has been developed and implemented using finite element software. The results obtained with the model have been verified by comparison with results from an independent numerical method. The results show that the height distribution of the topography has a significant influence on the contact stiffness but that the curvature of the roughness is of minor importance. The contact model that was developed for determining the apparent contact area and the distribution of the mean contact pressure could thus be based on a limited set of height parameters that describe the surface topography. By operating on the calculated apparent pressure distribution with a transformation function that is based on both height and curvature parameters, the real contact area can be estimated when the apparent contact state is known. The model presented is also valid for cases with local plastic flow in the bulk material.
Place, publisher, year, edition, pages
2003. Vol. 254, no 11, 1180-1188 p.
bearing area curve, contact area, contact stiffness, finite element method, micro-slip, algorithm
IdentifiersURN: urn:nbn:se:kth:diva-22827ISI: 000185448900018OAI: oai:DiVA.org:kth-22827DiVA: diva2:341525
QC 201005252010-08-102010-08-10Bibliographically approved