Change search
ReferencesLink to record
Permanent link

Direct link
Microstructure of long-and short-fiber reinforced injection molded polyamide
KTH, School of Engineering Sciences (SCI), Aeronautical and Vehicle Engineering, Lightweight Structures.
1993 (English)In: Polymer Composites, ISSN 02728397 (ISSN), Vol. 14, no 2, 116-125 p.Article in journal (Refereed) Published
Abstract [en]

The variation of fiber orientation and content within injection molded rectangular plates is investigated. Fiber orientation and volume fraction are measured using metallographic polishing and a newly develop image-analysis system: fiber weight-fractions are measured using an ashing method.

Place, publisher, year, edition, pages
1993. Vol. 14, no 2, 116-125 p.
Keyword [en]
Image analysis, Injection molding, Microstructure, Polyamides, Shear stress, Flow mechanism, Long fiber polyamide, Orientation of fiber, Short fiber polyamide, Fiber reinforced materials
National Category
Applied Mechanics
URN: urn:nbn:se:kth:diva-80057OAI: diva2:495939

Correspondence Address: Toll, S.; Ecole Polytechnique Federale de, Lausanne, Lausanne, Switzerland

NR 20140805Available from: 2012-02-09 Created: 2012-02-09 Last updated: 2014-04-08Bibliographically approved

Open Access in DiVA

No full text

Other links

Search in DiVA

By author/editor
Toll, Staffan
By organisation
Lightweight Structures
Applied Mechanics

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 18 hits
ReferencesLink to record
Permanent link

Direct link