MEMS 30 mu m-thick W-band Waveguide Switch
2012 (English)In: European Microwave Week 2012: "Space for Microwaves", EuMW 2012, Conference Proceedings - 42nd European Microwave Conference, EuMC 2012, IEEE , 2012, 1055-1058 p.Conference paper (Refereed)
This paper presents for the first time a novel concept of a MEMS waveguide switch based on a reconfigurable surface, whose working principle is to short-circuit or to allow for free propagation of the electrical field lines of the TE10 mode of a WR-12 rectangular waveguide. This transmissive surface is only 30 mu m thick and consists of up to 1260 reconfiguring cantilevers in the waveguide cross-section, which are moved simultaneously by integrated MEMS comb-drive actuators. For the first fabrication run, the yield of these reconfigurable elements on the chips was 80-86%, which still was good enough for resulting in a measured insertion loss in the open state of better than 1dB and an isolation of better than 20dB for the best designs, very wideband from 62 to 75GHz. For 100% fabrication yield, HFSS simulations predict that an insertion loss in the open state of better than 0.1dB and an isolation of better than 30dB in the closed state are possible for designs with 800 and more contact points for this novel waveguide switch concept.
Place, publisher, year, edition, pages
IEEE , 2012. 1055-1058 p.
, European Microwave Conference, ISSN 2325-0305
RF MEMS, reconfigurable surface, waveguide switch
Electrical Engineering, Electronic Engineering, Information Engineering
IdentifiersURN: urn:nbn:se:kth:diva-138398ISI: 000325100700267ScopusID: 2-s2.0-84874597989ISBN: 978-2-87487-026-2OAI: oai:DiVA.org:kth-138398DiVA: diva2:681486
2012 42nd European Microwave Conference, EuMC 2012 - Held as Part of 15th European Microwave Week, EuMW 2012; Amsterdam; Netherlands; 29 October 2012 through 1 November 2012
QC 201312202013-12-202013-12-192013-12-20Bibliographically approved