Change search
ReferencesLink to record
Permanent link

Direct link
Development of a regeneration procedure for commercial automotive three-wy catalysts
KTH, Superseded Departments, Chemical Engineering and Technology.
2004 (English)Licentiate thesis, comprehensive summary (Other scientific)
Abstract [en]

Car exhaust catalysts were introduced in the early 1980’s, to limit the release of pollutants such as hydrocarbons, carbon monoxides and nitrogen oxides. These catalysts contain noble metals such as palladium (Pd), platinum (Pt) and rhodium (Rh) and are able to simultaneously abate all three of the above-mentioned pollutants, hence the name three-way catalyst (TWC). The exposure to high temperatures (800-1000 °C) during operation and the presence of additives in petrol such as lead, calcium, silicon, magnesium, manganese, chromium, sulphur and phosphorus will after a certain time start to lower the overall effectiveness of the catalyst. These effects are either of a mechanical or a chemical nature. High temperatures reduce the active area by causing the noble metals to agglomerate and sinter whereas the additives alter the activity by either fouling the pores of the support material (phosphorus) or by interacting with the metals (sulphur and lead).

The main objective of this work was to develop a method to redisperse the catalytically active sites, comprising Pd, Pt and Rh on the washcoat surface, in an effort to regain lost catalyst activity. For this purpose, a wide spectrum of different commercial car exhaust catalysts containing varying noble metal loadings, aged under various driving conditions and with mileages ranging from 30 to 100 000 km were evaluated.

The influence of a thermal treatment in a controlled gas atmosphere, such as oxygen or hydrogen and a redispersing agent, e.g. chlorine, on the activity of TWC was investigated by means of laboratory-scale activity measurements. Several complementary characterisation methods such as SEM/TEM, XRD, BET and TPR were used to verify the effects of the regeneration treatments on the catalyst morphology (Paper I). Partial regeneration of catalyst activity and noble metal dispersion was achieved after thermal treatment in an oxygen-chlorine rich atmosphere at temperatures below 500 °C.

Finally, an investigation of the effects of an oxy-chlorine thermal treatment for regeneration of a ‘full-scale’ commercial automotive three-way catalyst was performed. Catalyst activity and performance prior to and after the oxy-chlorine thermal treatment was measured on a test vehicle in accordance with the European driving cycle (EC2000). The catalyst surface was further characterised using XRD and EDX (Paper II). Improved catalyst activity for a high mileage catalyst could be observed, with emissions lowered by approximately 30 to 40 vol% over the EC2000 driving cycle

Place, publisher, year, edition, pages
2004. , 24 p.
Trita-KET, ISSN 1104-3466 ; 204
Keyword [en]
deactivation, fouling, sintering, poisoning, palladium, rhodium, regeneration, dispersion, thermal gas treatment, oxy-chlorine, TWC, automotive catalyst
National Category
Other Engineering and Technologies not elsewhere specified
URN: urn:nbn:se:kth:diva-367OAI: diva2:9505
Available from: 2005-08-04 Created: 2005-08-04 Last updated: 2012-03-19

Open Access in DiVA

fulltext(2267 kB)1002 downloads
File information
File name FULLTEXT01.pdfFile size 2267 kBChecksum MD5
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Birgersson, Henrik
By organisation
Chemical Engineering and Technology
Other Engineering and Technologies not elsewhere specified

Search outside of DiVA

GoogleGoogle Scholar
Total: 1002 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 550 hits
ReferencesLink to record
Permanent link

Direct link