Endre søk
Begrens søket
1 - 2 of 2
RefereraExporteraLink til resultatlisten
Permanent link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Treff pr side
  • 5
  • 10
  • 20
  • 50
  • 100
  • 250
Sortering
  • Standard (Relevans)
  • Forfatter A-Ø
  • Forfatter Ø-A
  • Tittel A-Ø
  • Tittel Ø-A
  • Type publikasjon A-Ø
  • Type publikasjon Ø-A
  • Eldste først
  • Nyeste først
  • Skapad (Eldste først)
  • Skapad (Nyeste først)
  • Senast uppdaterad (Eldste først)
  • Senast uppdaterad (Nyeste først)
  • Disputationsdatum (tidligste først)
  • Disputationsdatum (siste først)
  • Standard (Relevans)
  • Forfatter A-Ø
  • Forfatter Ø-A
  • Tittel A-Ø
  • Tittel Ø-A
  • Type publikasjon A-Ø
  • Type publikasjon Ø-A
  • Eldste først
  • Nyeste først
  • Skapad (Eldste først)
  • Skapad (Nyeste først)
  • Senast uppdaterad (Eldste først)
  • Senast uppdaterad (Nyeste først)
  • Disputationsdatum (tidligste først)
  • Disputationsdatum (siste først)
Merk
Maxantalet träffar du kan exportera från sökgränssnittet är 250. Vid större uttag använd dig av utsökningar.
  • 1. Abubakar, Abdulkareem
    et al.
    Al-Wahaibi, Yahya
    Al-Wahaibi, Talal
    Al-Hashmi, Abdul-Aziz R.
    Al-Ajmi, Adel M.
    KTH.
    Eshrati, Mohammad
    Effect of Water-Soluble Drag-Reducing Polymer on Flow Patterns and Pressure Gradients of Oil/Water Flow in Horizontal and Upward-Inclined Pipes2017Inngår i: SPE Journal, ISSN 1086-055X, E-ISSN 1930-0220, Vol. 22, nr 1, s. 339-352Artikkel i tidsskrift (Fagfellevurdert)
    Abstract [en]

    Experimental investigations of flow patterns and pressure gradients of oil/water flow with and without drag-reducing polymer (DRP) were carried out in horizontal and upward-inclined acrylic pipe of 30.6-mm inner diameter (ID). The oil/water flow conditions of 0.1- to 1.6-m/s mixture velocities and 0.05-0.9 input oil volume fractions were used, and 2,000 ppm master solution of the water-soluble DRP was prepared and injected at controlled flow rates to provide 40 ppm of the DRP in the water phase at the test section. The flow patterns at the water-continuous flows were affected by the DRP, whereas there were no tangible effects of the DRP at the oil-continuous flow regions. The upward inclinations shifted the boundaries between stratified flows and dual continuous flows, and the boundaries between dual continuous flows and water-continuous flows to lower mixture velocities. This means that the inclinations increased the rate of dispersions. The frictional pressure gradients for both with and without DRP slightly decreased with inclinations especially at low mixture velocities, whereas the significant increases in the total pressure gradients with the inclinations were more pronounced at low mixture velocities. The inclinations did not have a major effect on the drag reductions by the DRP at the high mixture velocities and low input oil-volume fractions where the highest drag reductions recorded were 64% at 0 degrees inclination and 62% at both + 5 degrees and +10 degrees inclinations.  However, the inclinations increased the drag reductions as the input oil-volume fractions were increased before phase-inversion points.

  • 2.
    Al-Ajmi, Adel M.
    et al.
    KTH, Skolan för arkitektur och samhällsbyggnad (ABE), Mark- och vattenteknik (flyttat 20130630), Teknisk geologi och geofysik. Department of Petroleum and Chemical Engineering, Oman .
    Zimmerman, Robert W.
    KTH, Skolan för arkitektur och samhällsbyggnad (ABE), Mark- och vattenteknik (flyttat 20130630), Teknisk geologi och geofysik.
    A new 3D stability model for the design of non-vertical wellbores2006Konferansepaper (Fagfellevurdert)
    Abstract [en]

    The Mohr-Coulomb failure criterion is known to be too conservative in estimating the critical mud pressure required to maintain wellbore stability, due to ignoring the strengthening effect of the intermediate principal stress. To eliminate this deficiency, we have developed a new analytical model to estimate the mud pressure required to avoid shear failure at the wall of non-vertical boreholes (i.e., the collapse pressure). This has been achieved by using a linear elastic and isotropic constitutive model for the stresses, and the Mogi-Coulomb criterion to predict failure. For comparison, the stability analysis has been also carried out using Mohr-Coulomb, the modified Lade criterion, and the Drucker-Prager criterion. We have found that implementing the Mogi-Coulomb law instead of Mohr-Coulomb does indeed lessen the conservative nature of the wellbore stability analysis. In general, the Mogi-Coulomb criterion gives an estimate of the collapse pressure that is similar to that given by the modified Lade criterion in polyaxial stress states, and similar to Mohr-Coulomb in triaxial stress states. By comparison, the Drucker-Prager criterion always underestimates the required mud weight. The developed 3D stability model has been applied in a field case study.

1 - 2 of 2
RefereraExporteraLink til resultatlisten
Permanent link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf