A study has been conducted to shed light on the effect of cultivation parameters on growth and chemical composition of Saccharina latissima. Longline cultivation took place at two separate locations in the Koster archipelago on the Swedish west coast, centred around three experiments that explored duration of pre-deployment hatchery processes (Exp 1), deployment and harvest time-frames (Exp 2), and cultivation at 2 m vs. 4 m depth (Exp 3). For all experiments the effects of these parameters were evaluated in terms of size/weight of specimens, and for experiments Exp 2 and Exp 3, concentrations of moisture, ash, carbohydrates, proteins, fatty acids, phlorotannins and common heavy metals were determined.

The specific parameters used in this study are likely to vary from site to site, nevertheless trends were observed that resonate in the literature, and these lead to some general recommendations. The weight of harvested kelp blades was higher for the later harvest, earlier deployment and when grown at a shallower depth. Carbohydrates concentration increased with later harvests and at shallower depth. Later harvests also increased the concentration of phlorotannin, while ash and total fatty acids decreased. Protein and fucoidan content was higher for the deeper lines. Growth and chemical composition of the seaweeds showed only minor differences between the two study sites, mostly relating to heavy metal content.

Laminarin is a low-molecular-weight polysaccharide found in seaweed (kelp), often in equal concentrations to that in the commercially important hydrocolloid alginate. However, while alginate can be easily recovered by dissolution followed by acid precipitation, for laminarin, there is no such straightforward way of recovering it. Laminarin can be used as dietary fiber and, if efficiently extracted, it may be used for functional food/feed applications and as a component in plant defense stimulants for agriculture. One way of concentrating laminarin from dilute solutions is to press the solution through ultrafine membranes that the molecules cannot pass through. When alginate is extracted, an acid pretreatment step is used and the dilute acid residue from that process also contains laminarin. We used cross-flow filtration to concentrate laminarin from Saccharina latissima, retrieving it from the dilute acid solution of the acid pretreatment of an alginate extraction. Three ceramic membranes with 5, 15, and 50 kDa molecular weight cutoffs were used, and the pressure, temperature, and feed velocity were altered to reveal which parameters controlled the flow through the membrane and how efficiently laminarin was concentrated. The effects on laminarin extraction for fresh vs. frozen biomass were evaluated showing that frozen biomass releases more laminarin with a similar biomass homogenization technique. Thermal and microbial degradation of the feed components was studied during the course of the filtrations, showing that microbial degradation can affect the laminarin concentration, while the temperature of the process ~ 65 °C had little impact on laminarin. The techniques used to monitor the components in the feed and permeate during filtration were nuclear magnetic resonance, 1H-NMR, and size exclusion chromatography. The filtrations were performed in a pilot-size filtration unit with ceramic membranes (ZrO2/TiO2, TiO2-Al2O support, 0.08 m2). To be able to operate without quick membrane fouling, the most important parameter was to have a high liquid velocity over the membrane, 4.7 m s−1. A good technique to concentrate laminarin was to prefilter it through a 50-kDa membrane using 2 bar liquid pressure and to concentrate it over a 5-kDa membrane using 5-bar liquid pressure. With these settings, the liquid flux through the filter became 60–80 and 30–40 L m−2 h−1 over the 50-kDa and 5-kDa membrane.

Linseed oil was graft modified with maleic anhydride and introduced into alginate by co-extrusion, producing alginate hybrid filaments. A straightforward grafting of maleic anhydride onto the oil backbone produced the modified oil. Additional esterification with n-dodecanol was also investigated. The structures of the modified oils were verified with 2D-NMR. The modified oil was mixed with alginate and extruded into CaCl2, forming thin filaments with diameters in the 130-260 mu m range. The impact of oil integration into the alginate filaments was assessed, with special emphasis on stress-at-break, and compared to values predicted by an empirical model relating the "stress to alginate concentration" ratio to prevailing conditions during filament drawing. Analogous alginate filaments were prepared with hydrochloric-, oxalic- and phytic acid calcium salts for comparison with alginate-oil hybrids to reveal the induced impact, with respect to the composition and charge, on the tensile performance.

Saccharina latissima biomass cultivated along the Swedish west coast was subjected to four different scalable preservation methods after harvest; freezing, sun-drying, oven-drying and ensiling. Freeze-drying and freezing at -80 ?C were also included to provide dry and wet references. The effects of the different preservation methods on the composition of Saccharina biomass (on dry weight, DW, basis), and the recovery as well as properties of high-quality protein, alginate and biogas were evaluated. Sun-drying significantly reduced protein, alginate and fatty acid content of the seaweeds and thereby concentrated ash in the biomass compared to the other methods. Protein/amino acids and fatty acids were significantly concentrated in ensiled biomass, while mannitol and laminarin were reduced compared to the other biomasses. Oven-drying and -20 ?C freezing affected the composition the least, with lower ash content and alterations in some specific amino and fatty acids. Sun-drying and ensiling resulted in significantly lower protein solubility at high pH compared to the other biomasses which translated into the lowest total seaweed protein recovery using the pH-shift process. Highest protein yield was obtained with the freeze-dried reference. Ensiling lead to a significant decrease in the molecular weight of alginate, while sun-drying caused a negative effect on alginate by inducing a shift in the guluronic and mannuronic acids composition of alginate. Sun-drying gave the lowest methane yield in the anaerobic digestion experiments while freezing at -80 ?C gave the highest yield, closely followed by freezing at -20 ?C and ensiling. To conclude, preservation methods must be carefully chosen to protect the valuable component in Saccharina latissima, and to achieve an efficient downstream processing ultimately yielding high quality products as part of a seaweed biorefinery.

Kelps can be included in integrated multitrophic aquaculture (IMTA) where their growth and quality might benefit from the nutrient load released by other species like finfish and mussels transforming effluents from the cultured animals into valuable products. We studied how different nutrient concentrations affect growth, photosynthesis, chemical composition and pigment content of the kelp Saccharina latissima. We exposed kelps to natural seawater, water enriched to levels of ammonium and nitrate simulating finfish cage waste (IMTA1) and a combination of such enrichment with natural effluents coming from mussels (IMTA2). The algal biomass was higher and produced elevated total organic content when exposed to both IMTA1 and IMTA2. The photosynthetic responses in terms of relative electron transfer rate (rETRmax), PSII saturation irradiance (Ek) and total nitrogen content were also positively affected by both IMTA1 and IMTA2. We found a significant enhancement in pigment content only when algae were exposed to the strongest enrichment of our study (IMTA2). Finally, we found a positive relationship between rETRmax and growth, and the content of chlorophyll a and fucoxanthin. Our results show significant physiological responses of S. latissima to nutrient enrichment mimicking IMTA settings, as well as the benefit of added nutrients through a boost in photosynthetic activity that leads to higher kelp biomass and pigment production. This study suggests that modest nitrogen enrichment such as the one in our IMTA2 setup is enough to generate not only higher kelp biomass, but also an increased biomass quality with potentially higher market value.

A series of alginate fractions with significant differences in molecular weight and uronic acid compositions were produced by consecutive fractionation and converted to thin and strong cross-linked polymer filaments via extrusion into calcium, aluminum, or polyaluminum (PolyAl) polyvalent solutions followed by drawing and drying. Models were elaborated to relate the alginate uronic acid composition to the tensile performance in both the wet gel filament and the dry filament states. The wet gel model was compared to the theory of the unidirectional elongation of charged polyelectrolyte gels based on the classical rubber elasticity of dilated polymer networks, extended to include the contributions of non-Gaussian chain extensions and the effect of electrostatic interactions. The theory of equilibrium swelling pressure was applied to describe the observed shrinkage of the alginate gels following immersion in a polyvalent solution. Congruent with the theoretical model of charged gels, the tensile performance of the gel filaments prepared from CaCl2 depended on the compositional ratio of guluronic acid dyads in the alginate fraction multiplied by the alginate concentration, while the tensile behavior of wet gel filaments prepared by AlCl3 instead resembled that of elastic solid materials and depended only on the alginate concentration. The dry filament tensile properties were greatly dependent on the preparation conditions, particularly the ratio of stress to alginate concentration and the nature of the ions present during filament drawing. The PolyAl solution effectively caused shrinkage of alginate to a strong extent, and the resulting filaments behaved as highly stiff materials able to withstand stresses of approximately 500 MPa and having elastic moduli as high as 28 GPa.

A new approach to process Saccharina latissima algal biomass was developed using sodium citrate and a polyvalent cation-specific resin to sequentially extract the alginate into several usable fractions. The fractionation was performed in a cyclic manner, utilizing a stepwise removal of the native polyvalent ions present in the algae to isolate fractions of alginate with different solubility in the presence of these ions. Sodium citrate was used in different concentrations in the extraction solution to remove polyvalent cations to adjust the alginate liberation while AMBERLITE IRC718 resin was added to further remove these ions and regenerate the extraction solution. Alginate was recovered by acid precipitation and analyzed for its uronic acid composition and molecular weight, and the carbohydrate compositions of the insoluble and soluble parts of the algal biomass residue were determined. Finally, the fractionation method was assessed with a life cycle analysis to determine the energy and water efficiency as well as the greenhouse gas emissions and the results were compared to conventional alkaline extraction. The results indicate that the energy and water use as well as the emissions are considerably lower for the cyclic extraction in comparison with the conventional methods.