Highly effective yet affordable non-noble metal catalysts are a key component for advances in hydrogen generation via electrolysis. The synthesis of catalytic heterostructures containing established Ni in combination with surface NiO, Ni(OH)(2), and NiOOH domains gives rise to a synergistic effect between the surface components and is highly beneficial for water splitting and the hydrogen evolution reaction (HER). Herein, the intrinsic catalytic activity of pure Ni and the effect of partial electrochemical oxidation of ultra-smooth magnetron sputter-deposited Ni surfaces are analyzed by combining electrochemical measurements with transmission electron microscopy, selected area electron diffraction, X-ray photoelectron spectroscopy, and atomic force microscopy. The experimental investigations are supplemented by Density Functional Theory and Kinetic Monte Carlo simulations. Kinetic parameters for the HER are evaluated while surface roughening is carefully monitored during different Ni film treatment and operation stages. Surface oxidation results in the dominant formation of Ni(OH)(2), practically negligible surface roughening, and 3-5 times increased HER exchange current densities. Higher levels of surface roughening are observed during prolonged cycling to deep negative potentials, while surface oxidation slows down the HER activity losses compared to as-deposited films. Thus, surface oxidation increases the intrinsic HER activity of nickel and is also a viable strategy to improve catalyst durability.

With recent advances in the field of single-atoms (SAs) used in photocatalysis, an unprecedented performance of atomically dispersed co-catalysts has been achieved. However, the stability and agglomeration of SA co-catalysts on the semiconductor surface may represent a critical issue in potential applications. Here, the photoinduced destabilization of Pt SAs on the benchmark photocatalyst, TiO2, is described. In aqueous solutions within illumination timescales ranging from few minutes to several hours, light-induced agglomeration of Pt SAs to ensembles (dimers, multimers) and finally nanoparticles takes place. The kinetics critically depends on the presence of sacrificial hole scavengers and the used light intensity. Density-functional theory calculations attribute the light induced destabilization of the SA Pt species to binding of surface-coordinated Pt with solution-hydrogen (adsorbed H atoms), which consequently weakens the Pt SA bonding to the TiO2 surface. Despite the gradual aggregation of Pt SAs into surface clusters and their overall reduction to metallic state, which involves >90% of Pt SAs, the overall photocatalytic H2 evolution remains virtually unaffected.

The development of new electrochromic materials and devices, like smart windows, has an enormous impact on the energy efficiency of modern society. One of the crucial materials in this technology is nickel oxide. Ni-deficient NiO shows anodic electrochromism, whose mechanism is still under debate. We use DFT+U calculations to show that Ni vacancy generation results in the formation of hole polarons localized at the two oxygens next to the vacancy. In the case of NiO bulk, upon Li insertion or injection of an extra electron into Ni-deficient NiO, one hole gets filled, and the hole bipolaron is converted into a hole polaron well-localized at one O atom, resulting from the transition between oxidized (colored) to reduced (bleached) state. In the case of the Ni-deficient NiO(001) surface, the qualitatively same picture is obtained upon embedding Li, Na, and K into the Ni surface vacancy, reinforcing the conclusion that the electron injection, resulting in the filling of the hole states, is responsible for the modulation of the optical properties of NiO. Hence, our results suggest a new mechanism of Ni-deficient NiO electrochromism not related to the change of the Ni oxidation states, i.e., the Ni2+/Ni3+ transition, but based on the formation and annihilation of hole polarons in oxygen p-states.

Graphene oxide finds applications in different fields of science, including energy conversion. Electrochemical reduction of graphene oxide (GO) significantly improves its conductivity. However, the kinetics of this process depends on the solvent, supporting electrolyte, pH, and numerous other factors. Most studies report the macroscopic views and ex-situ properties of reduced GO. To expand the knowledge about GO reduction, in this study, we used cyclic voltammetry (CV), simultaneous 2 points and 4 points resistance measurement (s24), conductive atomic force microscopy (AFM), and theoretical calculations. Using CV, we demonstrated that the choice of supporting electrolyte (KCl or LiCl) influences the potential range in which electrochemical GO reduction occurs. The activation energy of this process was estimated to be below 30 kJ mol(-1) in both electrolytes, being significantly lower than that required for thermal reduction of GO. Simultaneous in situ s24 resistance measurements suggest that GO films reach a highly conductive state at deep negative potentials, with an abrupt, irreversible switch from non-conductive to the conductive state. However, conductive AFM presents a more exact picture of this process: the reduction of GO films starts locally while the formed conductive islands grow during the reduction. This mechanism was confirmed by theoretical calculations indicating that the reduction starts on isolated oxygen-functional groups over the GO basal plane, while clustered OH groups are more difficult to reduce. The presented results can help in tailoring reduced GO for a particular electrochemical application by precisely controlling the reduction degree and percentage of the conductive area of the reduced GO films.

Energy-efficient hydrogen production is one of the key factors for advancing hydrogen-based economy. Alkaline water electrolysis is the main route for the production of high-purity hydrogen, but further improvements of hydrogen evolution reaction (HER) catalysts are still needed. Industrial alkaline electrolysis relies on Ni-based catalysts, and here we describe a drastic improvement of HER activity of Ni in alkaline media using several model catalysts for HER, obtained upon nickel surface modification in the aqueous solution of rhodium salts, where a spontaneous deposition of rhodium takes place, based on the chemical displacement reaction 3Ni + 2Rh3+ = 3Ni2+ + 2Rh. In the case of smooth Ni-poly electrodes, HER activity surpasses the activity of Pt-poly after just 30 s of exchange with Rh. SEM analysis showed that Rh is uniformly distributed, and that surface roughness changes are lower than 10%, which is in agreement with the electrochemical measurements. Furthermore, XPS analysis has shown effective incorporation of Rh in the surface, while DFT calculations suggest that hydrogen binding is significantly weakened on the Rh-modified Ni surfaces. Such tuning of the hydrogen binding energy is seen as the main factor governing HER activity improvements. The same galvanic displacement protocols were employed for nickel foam electrodes and electrodeposited Ni on Ti mesh. In both cases, somewhat longer Rh exchange times are needed to obtain superior activities than for the smooth Ni surface, but within 10 min. HER overpotentials corresponding to -10 mA cm-2 for nickel foam and electrodeposited Ni electrodes, after modification with Rh, amounted to only -0.07 and -0.09 V, respectively. Thus, it is suggested that a fast spontaneous displacement of Ni with Rh could effectively boost HER in alkaline media with minor cost penalties with regards to energy saving in the electrolysis process.

Enhancing aluminium interaction with graphene-based materials is of crucial importance for the development of Al-storage materials and novel functional materials via atomically precise doping. Here, DFT calculations are employed to investigate Al interactions with non-doped and N-doped graphene nanoribbons (GNRs) and address the impact of the edge sites and N-containing defects on the material's reactivity towards Al. The presence of edges does not influence the energetics of Al adsorption significantly (compared to pristine graphene sheet). On the other hand, N-doping of graphene nanoribbons is found to affect the adsorption energy of Al to an extent that strongly depends on the type of N-containing defect. The introduction of edge-NO group and doping with in -plane pyridinic N result in Al adsorption nearly twice as strong as on pristine graphene. Moreover, double n-type doping via N and Al significantly alters the electronic structure of Al,N-containing GNRs. Our results suggest that selectively doped GNRs with pyridinic N can have enhanced Al-storage capacity and could be potentially used for selective Al electrosorption and removal. On the other hand, Al,N-containing GNRs with pyridinic N could also be used in resistive sensors for mechanical deformation. Namely, strain along the longitudinal axis of these dual doped GNRs does not affect the binding of Al but tunes the bandgap and causes more than 700-fold change in the conductivity. Thus, careful defect engineering and selective doping of GNRs with N (and Al) could lead to novel multifunctional materials with exceptional properties. [GRAPHICS]

Single-atom catalysts (SACs) are rapidly developing in various application areas, including electrocatalysis of different reactions, usually taking place under harsh pH/electrode potential conditions. Thus, a full atomic-level understanding of the nature of the active sites under realistic electrochemical conditions is needed, having in mind that the state of SACs active centers could be altered by the adsorption of spectating species. In this contribution, Density Functional Theory is employed to conduct thermodynamic analysis of SACs with metal atoms (Mn, Fe, Co, Ni, Cu, Ru, Rh, Pd, Ag, Ir, Pt, or Au) embedded into N4 moiety in graphene. Various surface electrochemical processes on such SACs are considered, their Pourbaix plots are constructed, and their activity, selectivity, and stability under operating conditions are discussed. It is demonstrated how adsorption of H, O and OH can cause blockage and restructuring of the active sites and alter the electronic structure. Furthermore, when one deals with metals with lower D-band filling, it is shown that metal center oxidation is preferred over the oxidation of carbon lattice. The effect of the state of the metal center on the reactivity of the carbon lattice is discussed in the case of Fe@N-4-graphene. Finally, a possible strategy for confirming the changes in the architecture of the SACs' active site by analyzing their vibration spectra is suggested.

Understanding the catalytic performance of different materials is of crucial importance for achieving further technological advancements. This especially relates to the behaviors of different classes of catalysts under operating conditions. Here, we analyzed the effects of local coordination of metal centers (Mn, Fe, Co) in graphene-embedded single-atom catalysts (SACs). We started with well-known M@N-4-graphene catalysts and systematically replaced nitrogen atoms with oxygen or sulfur atoms to obtain M@OxNy-graphene and M@SxNy-graphene SACs (x + y = 4). We show that local coordination strongly affects the electronic structure and reactivity towards hydrogen and oxygen species. However, stability is even more affected. Using the concept of Pourbaix plots, we show that the replacement of nitrogen atoms in metal coordinating centers with O or S destabilized the SACs towards dissolution, while the metal centers were easily covered by O and OH, acting as additional ligands at high anodic potentials and high pH values. Thus, not only should local coordination be considered in terms of the activity of SACs, but it is also necessary to consider its effects on the speciation of SAC active centers under different potentials and pH conditions.

Here, we evaluate three different noble metal co-catalysts (Pd, Pt, and Au) that are present as single atoms (SAs) on the classic benchmark photocatalyst, TiO2. To trap the single atoms on the surface, we introduced controlled surface vacancies (Ti3+-Ov) on anatase TiO2 nanosheets by a thermal reduction treatment. After anchoring identical loadings of single atoms of Pd, Pt, and Au, we measure the photocatalytic H-2 generation rate and compare it to the classic nanoparticle co-catalysts on the nanosheets. While nanoparticles yield the well-established the hydrogen evolution reaction activity sequence (Pt > Pd > Au), for the single atom form, Pd radically outperforms Pt and Au. Based on density functional theory (DFT), we ascribe this unusual photocatalytic co-catalyst sequence to the nature of the charge localization on the noble metal SAs embedded in the TiO2 surface.

Single layer low-dimensional materials are presently of emerging interest, including in the context of magnetism. In the present report, on-surface supramolecular architecturing was further developed and employed to create surface supported two-dimensional binary spin arrays on atomically clean non-magnetic Au(111). By chemical programming of the modules, different checkerboards were produced combining phthalocyanines containing metals of different oxidation and spin states, diamagnetic zinc, and a metal-free 'spacer'. In an in-depth, spectro-microscopy and theoretical account, we correlate the structure and the magnetic properties of these tunable systems and discuss the emergence of 2D Kondo magnetism from the spin-bearing components and via the physico-chemical bonding to the underlying substrate. The contributions of the individual elements, as well as the role of the electronic surface state in the bottom substrate, are discussed, also looking towards further in-depth investigations.