kth.sePublications KTH
Change search
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf
Global stability analysis of a 90°-bend pipe flow
KTH, School of Engineering Sciences (SCI), Centres, Linné Flow Center, FLOW. KTH, School of Engineering Sciences (SCI), Engineering Mechanics, Fluid Mechanics and Engineering Acoustics.ORCID iD: 0000-0002-8426-4833
Institute for Atmospheric and Climate Science, ETH Zürich, CH-8092 Zürich, Switzerland.
KTH, School of Engineering Sciences (SCI), Centres, Linné Flow Center, FLOW. KTH, School of Engineering Sciences (SCI), Engineering Mechanics, Fluid Mechanics and Engineering Acoustics.ORCID iD: 0000-0001-9627-5903
2020 (English)In: International Journal of Heat and Fluid Flow, ISSN 0142-727X, E-ISSN 1879-2278, Vol. 86, article id 108742Article in journal (Refereed) Published
Abstract [en]

The present work investigates the stability properties of the flow in a 90◦-bend pipe with curvature δ=R/Rc=1/3, with R being the radius of the cross-section of the pipe and Rc the radius of curvature at the pipe centreline. Direct numerical simulations (DNS) for values of the bulk Reynolds number Reb=UbD/ν between 2000 and 3000 are performed. The bulk Reynolds number is based on the bulk velocity Ub, the pipe diameter D, and the ki-nematic viscosity ν. The flow is found to be steady for Reb⩽2500, with two main pairs of symmetric, counter- rotating vortices in the section of the pipe downstream of the bend. The presence of two recirculation regions is detected inside the bend: one on the outer wall and the other on the inner side. For Reb⩾2550, the flow exhibits a periodic behaviour, oscillating with a fundamental non-dimensional frequency St=fD/Ub=0.23. A global stability analysis is performed in order to determine the cause of the transition from the steady to the periodic regime. The spectrum of the linearised Navier-Stokes operator reveals a pair of complex conjugate eigenvalues with positive real part, hence the transition is ascribed to a Hopf bifurcation occurring at Reb,cr≈2531, a value much lower than the critical Reynolds number for the flow in a torus with the same curvature. The velocity components of the unstable direct and adjoint eigenmodes are investigated, and they display a large spatial separation, most likely due to the non-normality of the linearised Navier-Stokes operator. Thus, the core of the instability, also known in the literature as the wavemaker, is sought performing an analysis of the structural sensitivity of the unstable eigenmode to spatially localised feedbacks. The region located 15◦downstream of the bend inlet, on the outer wall, is the most receptive to this kind of perturbations, and thus corresponds to where the instability originates. Since this region coincides with the outer-wall separation bubble, it is concluded that the instability is linked to the strong shear by the backflow phenomena. The present results are relevant for technical applications where bent pipes are frequently used, and their stability properties have hitherto not been studied.

Place, publisher, year, edition, pages
Elsevier BV , 2020. Vol. 86, article id 108742
Keywords [en]
Bent pipe, Global stability, Structural sensitivity, Eigenvalues and eigenfunctions, Hopf bifurcation, Navier Stokes equations, Oscillating flow, Reynolds number, Complex conjugate eigenvalues, Counter-rotating vortices, Critical Reynolds number, Global stability analysis, Non-dimensional frequency, Recirculation regions, Technical applications, Stability
National Category
Fluid Mechanics
Identifiers
URN: urn:nbn:se:kth:diva-291387DOI: 10.1016/j.ijheatfluidflow.2020.108742ISI: 000629999200031Scopus ID: 2-s2.0-85096703636OAI: oai:DiVA.org:kth-291387DiVA, id: diva2:1542772
Note

QC 20210408

Available from: 2021-04-08 Created: 2021-04-08 Last updated: 2025-02-09Bibliographically approved
In thesis
1. Shapes of pipes
Open this publication in new window or tab >>Shapes of pipes
2023 (English)Doctoral thesis, comprehensive summary (Other academic)
Alternative title[sv]
Former av rör
Abstract [en]

Curved pipes are ubiquitous in several industrial applications and biological systems. The study of flows through these configurations is therefore of significant practical interest.

In the present thesis, the modal stability of flows in both toroidal and spatially developing bent pipes is investigated to understand the onset of transition. In addition, turbulence characteristics and large-scale structures in flows through toroidal and helically coiled pipes are analysed.

The modal stability of steady flows through toroidal pipes is studied for values of the curvature approaching zero, i.e. the straight pipe, to provide further evidence of the fact that the Hagen–Poiseuille velocity profile is stable to infinitesimal perturbations for any Reynolds number.   

A novel computational technique is developed for computing the laminar pulsatile flow in a toroidal pipe. A characterisation of this flow for different values of the pulsation frequency and the pulsation amplitude is presented. Floquet theory is then applied to investigate how the stability is affected by the governing parameters, in particular the amplitude and the frequency of the pulsation.

The flows through spatially developing bent pipes are also studied for understanding how the transition changes with respect to the toroidal geometry. Both a 90°- and a 180°-bend pipe with the same curvature are investigated. A transition from steady to periodic regime is observed in both cases. The stability analysis reveals that the core of the instability is located at the outer wall of the bend, approximately 15° downstream of the bend inlet, for both pipes. Similar critical Reynolds numbers are also found.

Finally, the fully developed turbulent flow in toroidal and helical pipes is considered for studying the effect of torsion on the turbulence characteristics. Both curvature and torsion are found to significantly modify the anisotropy of the flow compared to the case of a straight pipe. Large-scale structures are extracted via proper orthogonal decomposition to assess the occurrence of the swirl switching.

Abstract [sv]

Krökta rör finns överallt i olika industriella tillämpningar och biologiska system. Att studera flöden genom dessa konfigurationer har därför ett betydande praktiskt intresse.   

I denna avhandling undersöks den modala stabiliteten hos flöden i både torusformade och rumsutvecklande krökta rör för att förstå övergången till turbulens. Dessutom analyseras turbulensegenskaper och storskaliga strukturer i flöden genom toroidformade och spiralformade rör.    

Den modala stabiliteten för stadiga flöden genom toroidformade rör studeras för värden på krökningen som närmar sig noll, d.v.s. det raka röret, för att ge ytterligare bevis på det faktum att Hagen–Poiseuille hastighetsprofilen är stabil mot små störningar för alla Reynoldstal.   

En ny beräkningsteknik har utvecklats för att beräkna det laminära pulserande flödet i ett torusformat rör. En karaktärisering av detta flöde för olika värden på pulsationsfrekvensen och pulsationsamplituden presenteras. Floquet-teori används sedan för att undersöka hur stabiliteten påverkas av de styrande parametrarna, i synnerhet amplituden och frekvensen av pulseringen.   

Flödena genom rumsutvecklande krökta rör studeras också för att förstå hur turbulens-övergången förändras med avseende på toroidgeometrin. Både ett 90°- och ett 180°-krökt rör med samma krökning undersöks. En övergång från stadigt till periodisk regim observeras i båda fallen. Stabilitetsanalysen avslöjar att instabilitetens kärna är belägen vid krökens yttervägg, cirka 15° nedströms böjinloppet, för båda rören. Liknande kritiska Reynoldstal är också hittad.     

Slutligen undersöks det fullt utvecklade turbulenta flödet i toroidala och spiralformade rör för att studera effekten av torsion på turbulensegenskaperna. Både krökning och torsion har visat sig signifikant modifiera flödets anisotropi jämfört med fallet med ett rakt rör. Storskaliga strukturer extraheras via proper orthogonal decomposition för att bedöma förekomsten av virvelväxling (swirl switching på engelska).

Place, publisher, year, edition, pages
Stockholm: KTH Royal Institute of Technology, 2023
Series
TRITA-SCI-FOU ; 2023:35
Keywords
Global stability, curved pipes, secondary flow, wall-bounded turbulence, Global stabilitet, krökta rör, sekundärflöde, turbulens
National Category
Fluid Mechanics
Research subject
Engineering Mechanics
Identifiers
urn:nbn:se:kth:diva-327313 (URN)978-91-8040-629-1 (ISBN)
Public defence
2023-06-13, F3, Lindstedtsvägen 26, Stockholm, 10:15 (English)
Opponent
Supervisors
Funder
Swedish Research Council, 2017-04421
Note

QC 230524

Available from: 2023-05-24 Created: 2023-05-23 Last updated: 2025-02-09Bibliographically approved

Open Access in DiVA

No full text in DiVA

Other links

Publisher's full textScopus

Authority records

Lupi, ValerioSchlatter, Philipp

Search in DiVA

By author/editor
Lupi, ValerioSchlatter, Philipp
By organisation
Linné Flow Center, FLOWFluid Mechanics and Engineering Acoustics
In the same journal
International Journal of Heat and Fluid Flow
Fluid Mechanics

Search outside of DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric score

doi
urn-nbn
Total: 179 hits
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf