Coastal global navigation satellite system (GNSS) stations equipped with a standard geodetic receiver and antenna enable water level measurement using the GNSS interferometry reflectometry (GNSS-IR) technique. By using GNSS-IR, the vertical distance between the antenna and the reflector surface (e.g., water surface) can be obtained in the vertical (height) reference frame. In this study, the signal-to-noise ratio (SNR) data from four selected stations over three months are used for this purpose. We determined the predominant multipath frequency in SNR data that is obtained using Lomb-Scargle periodogram (LSP) method. The obtained sea surface heights (SSH) are assessed using tide gauge observations regarding accuracy and correlation coefficients. In this study, we investigated daily and hourly GNSS observations and used single frequencies of GPS (L1, L2 and L5), GLONASS (L1 and L2), Galileo (L1, L5, L6, L7 and L8), and BeiDou (L2 and L7) signals to estimate the SSH. The results show that the optimal signals for extracting the SSH are the L1 signal for the GPS, Galileo, and GLONASS systems and the L2 signal for the BeiDou system. The accuracy and correlation parameters for the optimal GPS signal in the daily mode are 2 cm and 0.87, respectively. The same parameters for the optimal GLONASS signal are 4 cm and 0.91. However, the obtained accuracy and correlation coefficients using the best Galileo and BeiDou signals are reduced, i.e., 4 cm and 0.88 using Galileo and 12 cm and 0.52 by employing the Galileo signals, respectively. Our results also show that the GPS L1 signal is more consistent with the tide gauge data. In the following, using the time series derived from the L1 signal and tide gauge readings, the tidal frequencies are extracted and compared using the Least Square Harmonic Estimation (LS-HE) approach. The findings demonstrate that 145 significant tidal frequencies can be extracted using the GNSS-IR time series. The existence of an acceptable correlation between the tidal frequencies of the GNSS-IR and the tide gauge time series indicates the usefulness of the GNSS-IR time series for tide studies. From our results, we can conclude that the GNSS-IR technique can be applied in coastal locations alongside tide gauge measurements for a variety of purposes.