Locust bean gum, derived from the carob tree, was evaluated as a biobased adhesive in particleboard manufacturing, investigating the effect of adhesive amount, mat moisture content, and process parameters such as temperature and time. Single-layer particleboards prepared with locust bean gum showed that effective hydration of the polymer chains is necessary to achieve satisfactory interactions with wood and thus yield a sufficient particleboard strength. A mat moisture content below 30 % resulted in weak particleboards, which easily broke immediately after pressing. With increasing mat moisture content, while keeping the adhesive amount constant, the internal bond strength was increased. Moreover, with constant mat moisture contents (40 %), the internal bond strength increased when the adhesive amount was increased, even though not proportionally. With an increase from 9 % to 18 % adhesive, the internal bond strength was increased by more than 100 %. However, with a further increase in adhesive content from 18 % to 36 %, the increase in internal bond strength was statistically insignificant. Even with high mat moisture contents (35–45 %), larger lab-scale particleboards had internal bond strength that fulfilled standard requirements for P2 boards, commonly used for furniture in dry conditions (SS EN 312), when the pressing time was long enough (75 s/mm) to allow for water and vapors to be removed before releasing the pressure. Using biopolymers as adhesives, without extensive chemical modification and hazardous crosslinkers, could lead to a more benign and sustainable particleboard production. Since the chemistry and setting/curing processes of biopolymer-based adhesives differ from those of the fossil-based adhesives used today, increased understanding of how production parameters affect the properties of the particleboards prepared with biopolymers may pave the way for their better utilization in this field.